3DPrinting
3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed parts and devices.
The r/functionalprint community is now located at: or !functionalprint@fedia.io
There are CAD communities available at: !cad@lemmy.world or !freecad@lemmy.ml
Rules
-
No bigotry - including racism, sexism, ableism, homophobia, transphobia, or xenophobia. Code of Conduct.
-
Be respectful, especially when disagreeing. Everyone should feel welcome here.
-
No porn (NSFW prints are acceptable but must be marked NSFW)
-
No Ads / Spamming / Guerrilla Marketing
-
Do not create links to reddit
-
If you see an issue please flag it
-
No guns
-
No injury gore posts
If you need an easy way to host pictures, https://catbox.moe/ may be an option. Be ethical about what you post and donate if you are able or use this a lot. It is just an individual hosting content, not a company. The image embedding syntax for Lemmy is 
Moderation policy: Light, mostly invisible
view the rest of the comments
The main thing I'm wondering right now, is the MEK supposed to Boil? I feel like it should be, but at that point im also working with e Pressurised Vessel with very much Dangerous chemicals... thought's?
i;ve never used pressurized vapor baths, for anything. I'd certainly stay away from pressurized vapor baths using heated solvents that are also rather flammable (that's... got some exciting possibilities that I would let my worst enemy do first.) I'd use picture glass (or cheap ikea mirrors.) to build up a box. set it up outside where the vapors aren't a problem.
alternatively, a cheap-ass-fuck stock pot with a glass lid will also work fine, but don't seal it... and certainly don't use it for food when you're done.
as for if it should boil, it's boinling point is about 80 deg. C, so if you're seeing boiling, you either have somewhat impure MEK (which is fine,) or your temp measurement is off. It should still put enough vapor into the box that you can see it working though... it'll just work faster. its less advised to boil it off because, well. it works too fast usually.
please tell me you're doing all of this outside or with a ginormous fume hood that goes outside. (seriously, MEK is not to be underestimated.)
For what it's worth, if you have a pressure vessel and you want to make it go differently, reducing the pressure will have better effect (or so I'm told.)
I mean it wasn't boiling which I thought was the issue. The setup I got rn is a Very Solid glass Jar that was fully Sealed and heated to around 50°C on my Printer bed. Left my Prints in there for between 30 Minutes to a Whole day, and while it was a lot shinier afterwards, no changes in the lines or or layers where to be seen.
Safety wise I got a Gas Mask, Fitting Clothes and some other Saftey stuff around