3DPrinting

Hi All,

This will be difficult to pin down, but getting pointed in the right direction would be helpful.

Purchased a FlashForge AD5X ~5 weeks ago. Worked great, one button calibration out of the box, I proceeded to do what everyone does when learning: print a bunch of stuff, mix success and stumble over the usual stuff. Ie: Learned why you clean the bed, learned how supports work, deal with filament breaks etc etc.

About a week ago I had a print fail, it looked like there was a broken filament that wasn't being pushed. I do a cold pull on the nozzle, and was able to print successfully for a time (although there were some small features on some prints that seemed sloppy compared to previous prints).

After that though ALL my prints started to fail. Even after cleaning the bed, double checking bed/nozzle temp, I'd get bad adhesion. I'd also get the nozzle dragging through layers, as if the Z was off (even after running calibration repeatedly and before each print). There was some popping and oozing, which I put up to not storing my PLA dry (although ambient was only ~40%). However the problem persisted even with a freshly opened vac-sealed (confirmed seal was good) roll of PLA.

I ordered a replacement nozzle that arrives today, but can anyone give me some insight? I only ran ~2kg of PLA through, that seems like really premature wear; I must have done something wrong.

Thanks for anything putting me in the right direction.