1

I'll start out saying, i'm not very good with this stuff.... I have an Ender 5+.
I had it setup with octoprint and klipper from a guide I found a couple years ago, and it worked OK for me to get klipper installed, working on octoprint, and pressure advance tuned ok ish.

Recently my SD Card became corrupt, and like an idiot I didn't have anything backed up.

So I'm trying to setup the system again from less than scratch and it's kicking my ass.

I've decided i'd like to try Mainsail, as it's interface looks interesting (no other reason) But I can't for the life of me get it working.

EVERY guide I try and follow seems to fail on the connect between klipper and the printer.

I can flash the klipper firmware successfully, and have updated the port ID in the printer.cfg file, but it always comes back to klipper not being able to see/access the port.

Any help would be appreciated here.

top 3 comments
sorted by: hot top controversial new old
[-] joemansmoke@lemmy.world 1 points 1 year ago

Also, make sure [include mainsail.cfg] is present in your printer.cfg file. Apparently this is important when changing frontends (octoprint -> mainsail).

[-] NixDev@programming.dev 1 points 1 year ago

Are you still having issues? I just rebuilt my e5p (Klipper, Fluidd, bigtreetech skr mini e3 v3, and new screen) and have been working out the bugs. Everything is working good so far, but still need to find tune the printer.

[-] ironhydroxide@partizle.com 2 points 1 year ago

Nope, found my problem with the install of mainsail being a permissions thing.

I'm still running the stock board, but have upgraded to a remote direct drive extruder.

this post was submitted on 23 Jun 2023
1 points (100.0% liked)

3DPrinting

15542 readers
289 users here now

3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed parts and devices.

The r/functionalprint community is now located at: !functionalprint@kbin.social or !functionalprint@fedia.io

There are CAD communities available at: !cad@lemmy.world or !freecad@lemmy.ml

Rules

If you need an easy way to host pictures, https://catbox.moe may be an option. Be ethical about what you post and donate if you are able or use this a lot. It is just an individual hosting content, not a company. The image embedding syntax for Lemmy is ![](URL)

Moderation policy: Light, mostly invisible

founded 1 year ago
MODERATORS