I’ve had the SV06 plus for around a month and it blows my Ender 3 S1 pro out of the water. The SV06 plus is faster, more sturdy and I’ve had very little printing errors with great quality. The power supply did go out in the Sovol. I could have gone through warranty but I upgraded to a meanwell power supply instead. I used it in an enclosure so I’m sure the power supply got hot and when I went to replace it I noticed the switch had a burnt pin so I replaced the switch also.

Had mine for about 3 months so far, and it’s working great. The first benchy out of the box printed perfect, but the next larger print wasn’t sticking to the bed. That was easily fixed by scrubbing the bed sheet with a scotch-brite pad and lots of soap. The sheet it comes with has white grid lines painted on that tend to flake off and stick to the print, which doesn’t look that great with darker filaments. Replaced it with a blank sheet from Amazon. I also installed Klipper, which made it a lot nicer: https://github.com/bassamanator/Sovol-SV06-firmware

It’s the worst printer I’ve ever tried.

When it works, it prints wonderfully. Much better than my Ender 3 v2 and even my Ender 3 S1 Pro.

BUT… about 85% of my prints failed horribly.