3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed parts and devices.
The r/functionalprint community is now located at: or !functionalprint@fedia.io
There are CAD communities available at: !cad@lemmy.world or !freecad@lemmy.ml
No bigotry - including racism, sexism, ableism, homophobia, transphobia, or xenophobia. Code of Conduct.
Be respectful, especially when disagreeing. Everyone should feel welcome here.
No porn (NSFW prints are acceptable but must be marked NSFW)
No Ads / Spamming / Guerrilla Marketing
Do not create links to reddit
If you see an issue please flag it
No guns
No injury gore posts
If you need an easy way to host pictures, https://catbox.moe/ may be an option. Be ethical about what you post and donate if you are able or use this a lot. It is just an individual hosting content, not a company. The image embedding syntax for Lemmy is 
Moderation policy: Light, mostly invisible
Started printing this filament shrinkage test and had to leave the house. When I came back, the whole upper half of the part had shifted after the first few layers, and it left two solid blobs attached and one ball of spaghetti. The magnetic bed doesn't appear to have moved. Part is still solidly adhered to the print bed. How did this happen, and how can I keep it from happening again?
Test failed successfully. Excess material hit the bed, cooled, head collided on next pass, layer shift. Keep the head clean and fine tune to eliminate over extrusion. If bed is not level and first layer bungled, same story after leveling and cleaning bed
This is the first print I've done after removing and thoroughly cleaning the nozzle, unclogging the hot end, and adjusting the extruder clamping force. Guess it could be that the bed needs leveling, I haven't checked it in a while.
Honestly starting to think this blue filament is cursed, something goes wrong every time I use it. (I do dry it thoroughly every time I take it out of storage)
Why would it be a clog if they're over-extruding?
Not entirely sure what "cold pull" means. I unscrewed the nozzle while the machine was powered off and the hot end was room temperature. Blasted the living hell out of the nozzle with a small torch, scrubbed it inside and out with a brass bristle brush, ran one of the bristles through the end of the nozzle. With the nozzle and ptfe out, I heated the hot end to 60 C to loosen the remaining chunk of filament and pushed it out the bottom with the handle of a needle file. It came out in one solid piece. Shined a light through both hot end and nozzle individually and it looked clear.
Did you hot tighten the nozzle while putting it back? Don't think it caused your current failure, but cold tightening can lead to more clogs in the future.
I think layer shifts can be caused by many different things, but the first thing I'd check is that the bed carriage can move freely and there isn't something mechanically blocking it, like a wire or a misplaced screwdriver. The second thing I'd check would be the belt and gears, so that the bed can't move without the stepper motor also spinning.
I hadn't heard of tightening the nozzle while hot, but I'll definitely give that a try
Thermal expansion is real. Have experienced loose nozzles when only cold tightened. Also as others have said, ensure belts are tight. If they're floppy enough to skip teeth on the steppers you'll definitely get layer shift from a light breeze. Monitor the next test and let us know how it goes!