I hadn't heard of tightening the nozzle while hot, but I'll definitely give that a try
Not entirely sure what "cold pull" means. I unscrewed the nozzle while the machine was powered off and the hot end was room temperature. Blasted the living hell out of the nozzle with a small torch, scrubbed it inside and out with a brass bristle brush, ran one of the bristles through the end of the nozzle. With the nozzle and ptfe out, I heated the hot end to 60 C to loosen the remaining chunk of filament and pushed it out the bottom with the handle of a needle file. It came out in one solid piece. Shined a light through both hot end and nozzle individually and it looked clear.
This is the first print I've done after removing and thoroughly cleaning the nozzle, unclogging the hot end, and adjusting the extruder clamping force. Guess it could be that the bed needs leveling, I haven't checked it in a while.
Honestly starting to think this blue filament is cursed, something goes wrong every time I use it. (I do dry it thoroughly every time I take it out of storage)
Started printing this filament shrinkage test and had to leave the house. When I came back, the whole upper half of the part had shifted after the first few layers, and it left two solid blobs attached and one ball of spaghetti. The magnetic bed doesn't appear to have moved. Part is still solidly adhered to the print bed. How did this happen, and how can I keep it from happening again?
True true
Number three will get you through most all fences, walls, and locked doors. Become ungovernable.
I'm from Arkansas, US. I identify more with my small town than with my state or nation. I also identify as a southerner, but somewhat reluctantly.
In times like these, I repeat the mantra: "At least you're not in Mississippi."
Weightless by Marconi Union if you want something relaxing, and anything by Alon Mor for some more exciting, incredibly sound designed music.
That definitely looks promising. What's the workflow for getting the subscription data into the application?
I hear you. If I already had a list of the subscriptions I have, then yeah that would work. But I am a forgetful person, so I need (or I suppose, want) a tool that will get me to that starting point.
Podcasts! They're not all boring
Impressive. Very nice. Let's see the Duke of Savoy's lover.
Criticism is welcome!
Symbolism breakdown:
I feel somewhat confident in the geometry of this design, but I don't know anything about color theory so I'm open to suggestions on that. The present colors were picked with the help of an AI, followed by some mathematical derivation using software and hand tweaking.
Image description: retweet chain
@amminadabz : ANimal CRACKerss in my SOOP
@CBC_DankyDont : monkeys and rabbits loop the loop
@amminadabz : People say that white people have no culture
End image description.
I have been a bad plant parent and left my poor ficus in a hot sunny car for a few hours during a move. I've now gotten it to a place where it gets the right amount of sun (I think) and watered it, but it still isn't doing well. First one, now two leaves are drooping, and the top of the stem is shriveled. What can I do to help it?
I think I checked the e-steps when I upgraded the extruder (been I while, I don't remember) but I can check again