3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed parts and devices.
The r/functionalprint community is now located at: or !functionalprint@fedia.io
There are CAD communities available at: !cad@lemmy.world or !freecad@lemmy.ml
No bigotry - including racism, sexism, ableism, homophobia, transphobia, or xenophobia. Code of Conduct.
Be respectful, especially when disagreeing. Everyone should feel welcome here.
No porn (NSFW prints are acceptable but must be marked NSFW)
No Ads / Spamming / Guerrilla Marketing
Do not create links to reddit
If you see an issue please flag it
No guns
No injury gore posts
If you need an easy way to host pictures, https://catbox.moe/ may be an option. Be ethical about what you post and donate if you are able or use this a lot. It is just an individual hosting content, not a company. The image embedding syntax for Lemmy is 
Moderation policy: Light, mostly invisible
It will be a 240x280x70ish speaker stand. The first go ground with it flat and support free resulted in warping despite a 60°C chamber, so I stood it on its end, cut print speed by a third, and added the breaks to reduce stress.
This will take a while...
Note that the bottom has a chmafer, so although there's a shadow it's not warping.
Looks good so far. Make sure to vent/not breath too many ASA fumes.
Vent and filter! I have one of these under the bed and the printer is vented.
But it stinks so good!