3DPrinting

20890 readers

20 users here now

3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed parts and devices.

The r/functionalprint community is now located at: or !functionalprint@fedia.io

There are CAD communities available at: !cad@lemmy.world or !freecad@lemmy.ml

Rules

No bigotry - including racism, sexism, ableism, homophobia, transphobia, or xenophobia. Code of Conduct.
Be respectful, especially when disagreeing. Everyone should feel welcome here.
No porn (NSFW prints are acceptable but must be marked NSFW)
No Ads / Spamming / Guerrilla Marketing
Do not create links to reddit
If you see an issue please flag it
No guns
No injury gore posts

If you need an easy way to host pictures, https://catbox.moe/ may be an option. Be ethical about what you post and donate if you are able or use this a lot. It is just an individual hosting content, not a company. The image embedding syntax for Lemmy is ![](URL)

Moderation policy: Light, mostly invisible

founded 2 years ago

MODERATORS

andypiper@lemmy.world

j4k3@lemmy.world

GrayBackgroundMusic@lemmy.zip

Fuck. My. Life. 🙃 (i.imgur.com)

submitted 1 week ago* (last edited 1 week ago) by la508@lemmy.world to c/3dprinting@lemmy.world

33 comments fedilink hide all child comments

Full brims, mouse ears, with glue, without glue, higher bed temperature, lower bed temperature, flat base, concentric cutout base - whatever I try, I seem to be getting wank adhesion, major warping, and ultimately this shitshow.

Dry PLA, warm room, no draught, plate cleaned with IPA. I'm going to fucking punch this thing in its stupid fucking face.

Edit: Prevailing advice very much seems to be to bust out the Fairy liquid and give it a good scrub, so I'll try that. It's a Kobra Neo 2 so is auto-levelling, so I can't piss around with any of that stuff (as far as I know). Another quick question while I think about it, does everyone always print onto the bed at ~60°C? Because Orca Slicer's default for a textured PEI plate is 45°C, which seems mad. I think I tried it once and it was shite so turned it back up to 60.

you are viewing a single comment's thread
view the rest of the comments

[–] KairuByte@lemmy.dbzer0.com 3 points 1 week ago (1 children)

I need to point out, IPA isn’t magical. If you’re just giving it a quick swipe, or mopping it around, you’re not actually cleaning it you’re just moving the mess around. It’s fine for some in between stuff, but scrubbing with soap and warm water is going to be much more efficient at cleaning the plate.

[–] vodka@feddit.org 3 points 1 week ago

This is so important, you gotta wash the print surface, not disinfect it.

Wiping it with alcohol is good and all, but it needs some dishwashing detergent and a soft sponge every now and then.