CoupleMemes

563 readers

3 users here now

Community dedicated to memes that often hit a little too close to home. Respect the instance rules and remember that sharing these memes with your SO might 50/50 put you in the doghouse.

founded 8 months ago

MODERATORS

Picasso@sh.itjust.works

lena@gregtech.eu

684

It's the company that counts (sh.itjust.works)

submitted 2 weeks ago by Picasso@sh.itjust.works to c/Couplememes@sh.itjust.works

103 comments fedilink hide all child comments

you are viewing a single comment's thread
view the rest of the comments

[–] Sterile_Technique@lemmy.world 11 points 2 weeks ago (2 children)

The pressure from the wall is better than you might expect: nearly all shower heads have a pressure regulator inside of it - I'm assuming this is a legal requirement that manufacturers know users hate, cuz they tend to be easy to get at and bright red or blue. So, you'll want to pop the pressure regulator out of both heads.

Full wall spout pressure divided by two unregulated heads yields plenty on each side.

The issue you might run into is that your hot water will run out way faster than previously... then again, I live in an apartment, so I'm assuming our water heater is the cheapest shittiest one on the market, so you might have better luck on that front.

[–] Psythik@lemmy.world 2 points 2 weeks ago

Reason why I asked is because I've tried a dual showerhead before and it sucked ass. It was completely useless unless one of the nozzles was off.

[–] Imadethis@lemmynsfw.com 1 points 2 weeks ago (2 children)

I'm just curious if you know the answer: does the regulator attenuate the pressure downwards even if the overall pressure is below the target? Say the pressure at the spigot is 100 psi, but legally must be at 40psi, so the regulator attenuates it down to 40. If you divide it into the two shower heads, will the regulators simply attenuate it down to 40 psi, or cut it down to something like 20 psi?

[–] Sterile_Technique@lemmy.world 5 points 2 weeks ago

Anecdotally, one head w/ regulator at the start of the project vs 2 heads w/ regulators near the end of the project made a noticeable dip in pressure from each side. I thought the whole project was a bust - like, it was struggling to even rinse the soap off; but looked up ways to increase the pressure and found out about the regulators in the heads. Popped em out, and problem completely resolved.

You can still regulate the pressure manually too, using the valves on the t-connector. Ours are usually only open around 75% because they were murdering out hot water tank at full blast, and we'd run out of hot water with nearly every shower.

[–] MonkRome@lemmy.world 1 points 2 weeks ago

The regulator and water pressure both impact flow rate. Though as they said, remove the regulator and it's unlikely to be an issue.