34
Could use some help.
(lemmy.world)
So I'm trying to get my printer to a point where i can pretty consistently turn out high quality prints, but I'm at a point now where i get results like this. These two prints are from the same batch, same print job, and I'm completely clueless on how to fix it. I have an ender 3 v2 with a bltouch, I've adjusted the eccentric nuts, tightened the belts until the tips of my thumb and index finger couldn't tighten them any further, bed is level, using hatchbox pla. I know i can do ironing to fix the cosmetic problem, but I'd prefer to fix the root issue if possible.
I thought I’d add that it looks like it’s overextruded. So much that the filament is being “pushed” out and curling back around the nozzle.
It could be the e steps, flow rate, etc but it could also be that your Z offset needs to be adjusted back away a smidge.
That could be part of the inconsistent print since the tool head movement over one section of the bed vs another may be affected by the layer below based on how the filament curled there.
If you want to do a deep dive into adjusting/calibrating the Ender I did write up a bit here (although that post does relate to Klipper and I mention settings/adjustments for Klipper it starts purely with the physical printer itself and builds on it)
https://lemmy.world/comment/7904011
Ah, thank you for the advice and the link!