3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed parts and devices.
The r/functionalprint community is now located at: or !functionalprint@fedia.io
There are CAD communities available at: !cad@lemmy.world or !freecad@lemmy.ml
No bigotry - including racism, sexism, ableism, homophobia, transphobia, or xenophobia. Code of Conduct.
Be respectful, especially when disagreeing. Everyone should feel welcome here.
No porn (NSFW prints are acceptable but must be marked NSFW)
No Ads / Spamming / Guerrilla Marketing
Do not create links to reddit
If you see an issue please flag it
No guns
No injury gore posts
If you need an easy way to host pictures, https://catbox.moe/ may be an option. Be ethical about what you post and donate if you are able or use this a lot. It is just an individual hosting content, not a company. The image embedding syntax for Lemmy is 
Moderation policy: Light, mostly invisible
Oh, I'm a-doin' it.
This part is actually slightly outside the "safe print zone" dashed lines on my build plate. I put down like half a can of hairspray on it right before the nozzle descended. Wish me luck.
Good luck
Is this a 2d printer next to the 3D one?
Yeah, I keep all my printers in one place.
Well, except for the laser engraver. I guess you could consider that a "printer."
An engraver is more of a "remover" though
How's it going? 3 hours in looks like?
Getting away with it so far. We're just about done with the bottom deck and about to move on to the vertical walls. Apparently the entire thing has in fact not folded up like a taco and come off of the print bed, so that's nice.
The layer on top of the short section of infill covering the entire tray transitioning to the top fill is easily the longest time spent on a single layer I've ever seen in my life. I think it took more time than the first layer.
It was being careful lol
Sound like so far, so good, keep us posted.
The first layer on top of infill is basically a giant bridge. So yes, your slicer's strategy is to move the print head quite slowly. Usually the surface area isn't very large, so it's not a big deal. In this case, uh. Yeah.
Hope you did enough bottom wall layers. The big tray looks like it could be a bit flimsy.
Three all around. This is not meant to bear any weight. It's a work tray for fiddling around with knives and other small assemblies wherein I'm tired of having screws roll away and having to chase them on the carpet.
Poor a little silicone in afterwards for a soft, squishy bottom that will make grabbing small parts easier.
huh, hair spray, makes sense
i've been using an FDM-specific spray, but I bet hair spray is more cost effective
Ive been using unscented Suave hairspray for years and am still on the same can since 2020. Cost me like $8
There are some materials where that's probably a better idea. Polycarb or Nylon leap to mind. But for PLA, PETG, ABS/ASA, etc. I've found that hairspray works just fine. I've been doing it for years.
The cheapest you can get. Maximum sticky, minimum scents and aloe vera or whatever the fuck else. I use Aqua Net.
Good luck and let us know how it went.
As long as the borders are printing you should be golden. Not something you'd want to to often of course, depending on the printer, since you might strain the hardware at the extreme edges
