Some power tools and industrial solvents may have been used in the process.
I wouldn't have dared to show the before-picture even if I had one. It was bad. Really bad.
this post was submitted on 05 Mar 2026
31 points (97.0% liked)
Trees
7777 readers
12 users here now
A community centered around cannabis.
In the spirit of making Trees a welcoming and uplifting place for everyone, please follow our Commandments.
- Be Cool.
- I'm not kidding. Be nice to each other.
- Avoid low-effort posts
founded 2 years ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
I have a mighty. I've had to replace two rubber gaskets over about 6ish years, but that's as much normal wear as anything else, getting pinched when putting it back together. I do have to pop the screen out of the mouthpiece to effectively get it clean, but that's nothing. The one thing that did happen due to the IPA is the textured logo thing on the mouthpiece lock fell off after a couple years when the adhesive wore out.
I don't care about the logo. I was just wondered if the plastic is going to be fine. Thanks!
It'll be fine, only the holographic piece should not be immersed in IPA (and electronics ofc)
Feel free to soak the whole disassembled cooler chamber/head in alcohol
The orange grinder and filler that came with it, the clearish caps did get etched and foggy after an iso bath. Still functional, but ugly now. The original mouthpiece looks as new as when I got it, and I have a backup that I swap to when the first has restricted airflow from resin build up. Once both are dirty, I procrastinate a bit longer then do both at once.