I could be wrong, but fairly sure it's https://www.instagram.com/arsonprincess/ otherwise, here is the original video: https://www.youtube.com/watch?v=OAhgGWgUvBc

Thanks, I was worried about trying this, but if it's my only option I'll give it a go after I try another clean and resolder.

Thanks, I'll try and find the trace and solder a wire and maybe some supports.

Thanks,

awesome, I was struggling to figure out where tracers went, I'll try the light trick.

I did try using flux, I tried cleaning it with a toothbrush dipped in isopropyl alcohol, but I'll try water and bud tomorrow.

I think I'm using decent solder, I bought it from my local electronics store. It has no discernible branding but does contain a mixture which includes flux. My soldering iron is a fairly expensive one and has treated me well, but I don't think I take good care of the tip.

I'll try a sand as well tomorrow. Thanks for all the advice and encouragement :D

I love them

I think stick to the red if you're mounting it near the existing one. Regardless, if you do end up printing the other colours, please post. I think an opaque green would look really good.

Just had this issue, clearing cookies resolved it for me. Thanks everyone who posted the solution.

I have very little experience (6 prints so far on an ender 3).

When is the last time you've leveled your bed?

I had a similar tubing issue (no idea what the term is) where there would just be random tubes off the objects body.

I manually leveled and printed again and the print came out fine.

Good luck

Awesome design, very consistent with the rest of the parts

That is amazing, great colour choice.

It's currently really cold here so that might help,

The lower center of gravity is a brilliant idea.