57
gotta get a new printer
(programming.dev)
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
this post was submitted on 30 Mar 2024
57 points (89.0% liked)
Linux
48654 readers
381 users here now
From Wikipedia, the free encyclopedia
Linux is a family of open source Unix-like operating systems based on the Linux kernel, an operating system kernel first released on September 17, 1991 by Linus Torvalds. Linux is typically packaged in a Linux distribution (or distro for short).
Distributions include the Linux kernel and supporting system software and libraries, many of which are provided by the GNU Project. Many Linux distributions use the word "Linux" in their name, but the Free Software Foundation uses the name GNU/Linux to emphasize the importance of GNU software, causing some controversy.
Rules
- Posts must be relevant to operating systems running the Linux kernel. GNU/Linux or otherwise.
- No misinformation
- No NSFW content
- No hate speech, bigotry, etc
Related Communities
Community icon by Alpár-Etele Méder, licensed under CC BY 3.0
founded 5 years ago
MODERATORS
I bought a Samsung mono laser and printed approximately 400 pages on it before the fusor broke and would cost more than the entire printer did to replace.
I was past the 6-month warranty as well so I chucked it and bought a $10 Brother MFC-7860dw monoprinter from the thrift store that printed in the store.
It turned out that it would jam like the grateful Dead if it printed more than one page though.
Apparently that is a common issue with them and inside of the printer there is a small cork pad that gets twisted down and hits every time it picks up a new sheet of paper and the cork had gotten sticky somehow.
The fix for this incredibly complicated and delicate procedure is to open one side of the printer and take a piece of Scotch tape and cover over that tiny cork pad.
I did that 7 years ago and it still prints perfectly today.