this post was submitted on 28 Jan 2024
15 points (94.1% liked)

homeassistant

15575 readers
3 users here now

Home Assistant is open source home automation that puts local control and privacy first.
Powered by a worldwide community of tinkerers and DIY enthusiasts.

Home Assistant can be self-installed on ProxMox, Raspberry Pi, or even purchased pre-installed: Home Assistant: Installation

Discussion of Home-Assistant adjacent topics is absolutely fine, within reason.
If you're not sure, DM @GreatAlbatross@feddit.uk

founded 2 years ago
MODERATORS
GreatAlbatross@feddit.uk
greatalbatross@lemmy.world
15
Help using Ikea Tradfri shortcut buttons with a SONOFF Zigbee 3.0 USB Dongle (lemmy.world)
submitted 2 years ago by wazzup@lemmy.world to c/homeassistant@lemmy.world
5 comments fedilink hide all child comments
 

Hi all, happy to see a strong HA presence on Lemmy!

To start off, I know enough to be dangerous but not enough to always get the desired or expected outcomes.

I have a downloaded HA install to a bootable USB with all updates. I have also installed a SONOFF Zigbee Dongle and ensured that auto updates are enabled. After installing the SONOFF, I was able to configure ZHA and then also add the Ikea Tradfri shortcut button. These are currently the only two Zigbee devices.

Device info for the button confirms the button is being depressed with Logbook entry "Button_LR1 Remote Button Short Press - Turn On event was fired" - so I don't think I have a configuration issue.

I was hoping to configure a Scene where I could control lighting and TV with the shortcut button. As a test, via a HA configuration, I have created a Scene and added a light (via Wyze integration - works independently fine) and the button as Devices. There are two entities listed, one for the button battery and one for button identify. As configured on HA, this scene works as expected. The light turns on. However, depressing the shortcut button does nothing.

What am I doing wrong?

you are viewing a single comment's thread
view the rest of the comments
[โ€“] wazzup@lemmy.world 2 points 2 years ago (1 children)

As a follow up, this worked as you described. Thanks again.

Now, since it's the shortcut button, I had to load the blueprint and start working on the proper configuration so that I can do more with the switch - for example, double clicks, holding, etc...

Not quite there yet, but your response helped a lot.

[โ€“] jumpinf00l@aussie.zone 1 points 2 years ago

Glad I could help!