this post was submitted on 29 Aug 2026
86 points (97.8% liked)
PC Master Race
22260 readers
379 users here now
A community for PC Master Race.
Rules:
- No bigotry: Including racism, sexism, homophobia, transphobia, or xenophobia. Code of Conduct.
- Be respectful. Everyone should feel welcome here.
- No NSFW content.
- No Ads / Spamming.
- Be thoughtful and helpful: especially when new beginners have questions.
founded 3 years ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
They would have been so much better off using a 2 wire power connection like they use for car subs than this. Just tighten down the wires.
Nv:"Oh we made a connector that can peak at 600w" Everyone: "what about any safety leeway?" Nv:"What's that? Oh, AI Didn't say we needed that"
It's not really the wattage that's an issue.
If it ran at 600 volts, it would only be 1 amp.
But at 12v, it's 50 amps of current.
Which is a lot.
And it's not massively peaky/bursty, so it needs to withstand that constantly.
Pretty sure something like 10-15mm² cross section of copper is needed for that, which is a thick cable.
But, this is also a problem that has been solved elsewhere. For whatever reason, manufacturers have settled in a terrible solution.
As I understand it, not "manufacturers," Nvidia specifically. They designed the connector then basically forced PSU makers to follow because they're 90% of the market.