this post was submitted on 27 Sep 2023
14 points (100.0% liked)

Ask Electronics

3173 readers
1 users here now

For questions about component-level electronic circuits, tools and equipment.

Rules

1: Be nice.

2: Be on-topic (eg: Electronic, not electrical).

3: No commercial stuff, buying, selling or valuations.

4: Be safe.


founded 1 year ago
MODERATORS
 

Hey friends,

I have a two daisy chained shift registers (74AHC595) which are controlled via an ESP32. I want to set one output to high at a time before switching to the next.

The code seems to work, but the outputs O_9 and O_10 are not staying high (zoom) after setting them, whereas all the other ones are working fine. This is the used code snipped:

pinMode(SHIFT_OUT_DATA, OUTPUT);
pinMode(SHIFT_OUT_CLK, OUTPUT);
pinMode(SHIFT_OUT_N_EN, OUTPUT);
pinMode(SHIFT_OUT_LATCH, OUTPUT);

digitalWrite(SHIFT_OUT_N_EN, LOW);

uint16_t input_bin = 0b1000000000000000;

for(int i=0; i<17; i++){

    byte upper_byte = input_bin >> 8;
    byte lower_byte = input_bin & 0x00FF;

    digitalWrite(SHIFT_OUT_LATCH, LOW);
    shiftDataOut(SHIFT_OUT_DATA, SHIFT_OUT_CLK, MSBFIRST, lower_byte);
    shiftDataOut(SHIFT_OUT_DATA, SHIFT_OUT_CLK, MSBFIRST, upper_byte);
    usleep(10);
    digitalWrite(SHIFT_OUT_LATCH, HIGH);

    delay(10)
    input_bin = input_bin>>1;
} 

Is there anything I'm doing wrong, or any idea on where the problem may lie? I've already tried looking for shorts and other error sources, but the design was manufactured on a PCB and no assembly issues are noticeable.

you are viewing a single comment's thread
view the rest of the comments
[–] mvirts@lemmy.world 1 points 1 year ago (1 children)

Also try upping the usleep call?

[–] mvirts@lemmy.world 1 points 1 year ago* (last edited 1 year ago) (1 children)

Hmmmm do you want to write to both shift register at the same time? I say this because you're looping 16 times, but seem to be sending the high and low bytes out 16 times over rather than one bit each time, although you are shifting the input.

[–] mvirts@lemmy.world 1 points 1 year ago (1 children)

Maybe I'm getting ahead of myself, but maybe try using digitalWrite for a single bit instead of shiftDataOut?

Good idea, I've tried usleep after all lines, but no change..