3
Our rusty lathe (reddthat.com)

The company didn't pay the mortgage for over a year, and our nearly new lathe got very rusty.

you are viewing a single comment's thread
view the rest of the comments
[-] domdanial@reddthat.com 1 points 4 months ago

and after cleaned it up with wire brush and scotchbrite

[-] Machinist@lemmy.world 1 points 4 months ago

I was about to say, some elbow grease, and it's probably pretty okay under there.

Takes way more rust than you would think to ruin cast iron.

this post was submitted on 28 Jun 2024
3 points (100.0% liked)

Machinist

672 readers
6 users here now

From Newcomers to Old Timers, a community united by the Industry of Machining

Rules Don't post illegal stuff

Don't post Porn (no sexy aluminum surface finishes don't count)

Don't be an asshat (harassment, bullying etc.)

If you're going to post NSFW stuff, flag it as NSFW, It's ok to post shop Screwups (blood/cuts) just make sure to flag it as NSFW

and Finally make sure to have a good time :D

founded 1 year ago
MODERATORS