26
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
this post was submitted on 13 Mar 2024
26 points (100.0% liked)
Hardware
5021 readers
13 users here now
This is a community dedicated to the hardware aspect of technology, from PC parts, to gadgets, to servers, to industrial control equipment, to semiconductors.
Rules:
- Posts must be relevant to electronic hardware
- No NSFW content
- No hate speech, bigotry, etc
founded 4 years ago
MODERATORS
As it was already commented Host Memory Buffer can to some degree replace the DRAM cache (if the SSD supports it and even then the implementation can be bad). But the specification is from 2014 so unlikely that Laptops from up to 2015 will support it.
When there is no DRAM cache on the SSD, the SSD will use the NAND flash cells as cache. This results in more wear and a shorter lifetime. Also, when the SSD gets filled up, the SSD gets significantly slower since there will be less free NAND cells to use as Cache.
I think calling it a "cache" is not precise. The primary function of the DRAM is to hold the dictionary for translating logical addresses (e.g. sectors) from the OS to the physical addresses (which NAND chip, which bank etc.). This indirection is needed for the controller to do wear leveling without corrupting the filesystem.
On a SATA SSD without DRAM each read IO could mean 2 actual reads: first the dictionary to find the data and than the actual data being read. As you said HBM helps by eliminating this extra read.
The read and write caching is just a use of the remaining DRAM capacity. Since modern Operating Systems use the general RAM for the same function it is usually just a small increase to the throughput.
That data is still only cached on the DRAM, since it is losing its data when it is no longer powered.