First glass bed failure with PETG (programming.dev)

submitted 1 year ago by CameronDev@programming.dev to c/3dprinting@lemmy.ml

13 comments fedilink hide all child comments

I have been printing with PETG on glass for a little while now, and have gone through almost an entire roll. Yesterday I had my first print stick so hard that it delaminated the glass :(. I stopped using hairspray as it made the prints not stick at all, and printing bare glass was just fine. But something about yesterdays print made the glass give up. Is this how PETG + Glass normally fails? Works perfectly for years, and then suddenly fails?

you are viewing a single comment's thread
view the rest of the comments

[-] Vashtea@sh.itjust.works 5 points 1 year ago* (last edited 1 year ago)

Windex and gluestick are other options besides hairspray. And yes, you experience is not uncommon.

[-] CameronDev@programming.dev 2 points 1 year ago

Never tried Windex, but might give that a go. Gluestick had the same issue, lots of prints wouldn't actually stick so I had lots of failures :/ I vaguely remember someone suggesting sugar water, so might try that as well.

[-] UsernameLost@lemmy.ml 1 points 10 months ago

Windex to clean, let it dry for a bit, then a layer of gluestick has always worked for me, as long as the bed heats to 60°C for printing. The z offset has to be a bit different for PETG than PLA, which can be a bit tricky. I think (been a whole since I've printed PETG) it had to be a bit higher than PLA, so it wouldn't "squish" as much as PLA. Seemed a bit counterintuitive, but it solved most of my problems

this post was submitted on 06 Nov 2023

17 points (100.0% liked)

3D Printing

4351 readers

1 users here now

For everyhting 3D printing related.

Please be excellent to each other :)

Icon by Freepik, Banner photo by Thiago Medeiros Araujo

founded 4 years ago

MODERATORS

3dnudel@lemmy.ml