this post was submitted on 20 Nov 2025
12 points (100.0% liked)

3dprinting

61 readers
1 users here now

founded 4 months ago
MODERATORS
j4k3@lemmy.world
j4k3@piefed.world
12
Any ideas why my layers are lifting while printing? (media.piefed.world)
submitted 1 week ago by chocrates@piefed.world to c/3dprinting@piefed.world
10 comments fedilink hide all child comments
 

Eventually the nozzle snags and th while print pulls off the bed. I can't figure out what is happening

you are viewing a single comment's thread
view the rest of the comments
[–] chocrates@piefed.world 2 points 1 week ago

I think you nailed it. i changed the infill to cubic and slowed it down and its printing fine so far