That was hollowed, but chitubox's hollow tool is notoriously terrible and I admit I wasn't using the absolute cheapest amazon resin. The funko geometry is just awful for resin conservation, and if you're printing a whole one at once you're using up an absolutely insane amount of resin on supports (and a lot of those are going to be internal I guess, damn those heads are awful).

But yeah like... why would you even want to do that. The only appealing part of Funkos is the collectablity, if you're gonna make obvious fakes why not spend the same effort to make something infinitely cooler (and where it being 3D printed doesn't run counter to it's whole design ethos)???

I know it's a bit of a strawman to rail against thay bcz that's what nearly everyone is doing but uuuuugh