homeassistant

17004 readers

114 users here now

Home Assistant is open source home automation that puts local control and privacy first.
Powered by a worldwide community of tinkerers and DIY enthusiasts.

Home Assistant can be self-installed on ProxMox, Raspberry Pi, or even purchased pre-installed: Home Assistant: Installation

Discussion of Home-Assistant adjacent topics is absolutely fine, within reason.
If you're not sure, DM @GreatAlbatross@feddit.uk

founded 2 years ago

MODERATORS

GreatAlbatross@feddit.uk

greatalbatross@lemmy.world

Looking for a zigbee power meter plug without a switch (lemmy.ml)

submitted 3 weeks ago by SomeDudeFromSpace@lemmy.ml to c/homeassistant@lemmy.world

18 comments fedilink hide all child comments

As the title says, I'm looking for a plug that can measure power consumption, but does not even have a relay to power it on or off. I want it always to be on. The reason is that I'm tired of my smart plugs randomly turning off for no reason, even after I've updated them to the latest firmware version. Heck, I even have an automation in Home Assistant that turns them on again when it happens. I don't even know if what I'm looking for does even exist. I've been looking around and haven't found anything like it. If any of you fine folks know, please shout!

you are viewing a single comment's thread
view the rest of the comments

[–] brownmustardminion@lemmy.ml 1 points 3 weeks ago* (last edited 3 weeks ago) (5 children)

This is something I've been eyeing for the same use case: https://www.getzooz.com/zooz-zen15-power-switch/

Ive had great experiences with Zooz products in general, but haven't used this one (yet).

It does also control, but I'm sure if it's anything like their wall switches it has a setting to default to ON.

EDIT: Didn't see the ZigBee part of your post. Adding a z-wave dongle isn't too difficult if you're open to it. ZigBee sucks IMO.

[–] Ghoelian@piefed.social 4 points 3 weeks ago (3 children)

Why does ZigBee suck?

[–] brownmustardminion@lemmy.ml 1 points 3 weeks ago (2 children)

I've tried close to a hundred various devices, both ZigBee and Z-wave, and I've never had an issue with a Z-wave device but many with ZigBee.

I still use them here and there (mainly Hue bulbs), but I prefer Z-wave whenever possible.

Another factor is ZigBee devices tend to respond much slower. Z-wave light switches are instant on/off when instructed whereas my ZigBee lights always have a delay between 1-4 seconds.

[–] rmuk@feddit.uk 2 points 3 weeks ago

Definitely something screwy with your setup. I have over 70 ZigBee bulbs from a mixture of brands and even the most distant ones - two or three hops from the dongle - are rock solid. My bedroom has eight bulbs and is as far from the controller as it gets and it's rare for there to be a delay of more than half a second.

load more comments (1 replies)

load more comments (2 replies)