homeassistant

19332 readers

18 users here now

Home Assistant is open source home automation that puts local control and privacy first.
Powered by a worldwide community of tinkerers and DIY enthusiasts.

Home Assistant can be self-installed on ProxMox, Raspberry Pi, or even purchased pre-installed: Home Assistant: Installation

Discussion of Home-Assistant adjacent topics is absolutely fine, within reason.
If you're not sure, DM @GreatAlbatross@feddit.uk

founded 2 years ago

MODERATORS

GreatAlbatross@feddit.uk

greatalbatross@lemmy.world

How to switch a 5V led lamp? (piefed.ca)

submitted 6 months ago by GreatBlueHeron@piefed.ca to c/homeassistant@lemmy.world

17 comments fedilink hide all child comments

I've got a cheap salt lamp with a LED inside and it runs on a 5V wall wart. I think it originally had a USB plug but I cut that off and connected it to an old 5V power supply.

I've never used esp32, but I've been doing some reading and it seems like an esp32-c6 will allow me to do this with ZigBee.

Does this sound reasonable? Are there other options I should consider?

you are viewing a single comment's thread
view the rest of the comments

[–] Godnroc@lemmy.world 1 points 6 months ago

I did a similar project with a raspberry pi pico w and a glitter lamp. I ended up destroying the surface mount LEDs trying to solder them in to the board and instead replaced them with my own. The stirring motor was good, and a button to control it from the outside was a nice addition. Put the whole thing together with ESP Home and it's fantastic. Also allowed me to switch from disposable batteries to a standard USB cable for power.