Ask Electronics

3476 readers

1 users here now

For questions about component-level electronic circuits, tools and equipment.

Rules

1: Be nice.

2: Be on-topic (eg: Electronic, not electrical).

3: No commercial stuff, buying, selling or valuations.

4: Be safe.

founded 2 years ago

MODERATORS

DavideAndrea@discuss.tchncs.de

linker3000@discuss.tchncs.de

How do I shrink heatshrink in an explosion proof room? (lemmy.dbzer0.com)

submitted 4 days ago by Canonical_Warlock@lemmy.dbzer0.com to c/askelectronics@discuss.tchncs.de

29 comments fedilink hide all child comments

So I'm not sure what the right community for this is but I'm hoping yall can help. I'm a refrigeration service tech and recently I was tasked with replacing a sensor in a room used to store ethanol drums. Due to the nature of the room every device in it had to be rated explosion proof and I couldn't use any tools that could pose any risk of ignition (no heat gun, basically nothing with an electric motor, and definitely no open flames) while working in there. Normally when I splice wires I use heatshrink to cover the splice simply because it looks far more professional than electrical tape and it holds up better over time. However in this case I could not figure out any way of shrinking said heatshrink without posing a potential ignition hazard so I was stuck just wrapping the splice in tape. We do a lot of work for this company so I'm hoping to find a better solution for the next time I am in a similar situation.

So do any of you know any way to shrink heatshrink without posing an ignition hazard or am I stuck just using tape in those situations?

you are viewing a single comment's thread
view the rest of the comments

[–] Canonical_Warlock@lemmy.dbzer0.com 2 points 4 days ago

Yeah, I'll have to bring some of that along next time. We have it at the shop. I just didn't consider bringing it last time because it hadn't occured to me that heat shrink would be impossible to use in there until I was nearly done.