37
What's a good method for a non-technical person to short the terminals of two 0402 resistors ~1mm apart?
(lemmy.world)
I'm working on a mod kit for a popular item, but my target audience isn't likely to have a soldering iron. The majority of the project connects to an exposed ribbon connector, but I need to short two terminals to force a power supply on.
Any ideas on a method I could provide for people who can't solder? Maybe a strip of copper tape?
Hold a small piece of metal (paper clip?) between solder pads with a tweezer. Heat up tip of a metal fork/spoon (Sharp edge of fork could work better) on a stove. Take it from stove and use it immediately to melt the solder on one pad (seems like there is already enough solder there). I am not sure if it would work but maybe worth trying. Heating entire fork could be hard, so maybe something with smaller metal mass could work better, like a screwdriver, nail clipper etc).