100
IYKYK
(lemmy.world)
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
this post was submitted on 31 Aug 2024
100 points (87.9% liked)
Machinist
672 readers
1 users here now
From Newcomers to Old Timers, a community united by the Industry of Machining
Rules Don't post illegal stuff
Don't post Porn (no sexy aluminum surface finishes don't count)
Don't be an asshat (harassment, bullying etc.)
If you're going to post NSFW stuff, flag it as NSFW, It's ok to post shop Screwups (blood/cuts) just make sure to flag it as NSFW
and Finally make sure to have a good time :D
founded 1 year ago
MODERATORS
That's certainly a lot of machinists. I'm not production, about half my job is maintenance. Half my job is making parts. And half my job is screwing around.
In the shop I used to work at, everything but the routers were Haas, save for the one lone Hurco. I was the only one that could and would use it, and maintenance refused to touch it. I had to crawl in there with a hammer more times than I'd care to remember. So, I feel ya.