17
First glass bed failure with PETG (programming.dev)
submitted 1 year ago by CameronDev@programming.dev to c/3dprinting@lemmy.ml
13 comments fedilink hide all child comments

I have been printing with PETG on glass for a little while now, and have gone through almost an entire roll. Yesterday I had my first print stick so hard that it delaminated the glass :(. I stopped using hairspray as it made the prints not stick at all, and printing bare glass was just fine. But something about yesterdays print made the glass give up. Is this how PETG + Glass normally fails? Works perfectly for years, and then suddenly fails?

you are viewing a single comment's thread
view the rest of the comments
[-] CameronDev@programming.dev 4 points 1 year ago

I used to do tape, but i really like the smooth finish that bare glass gives. Glue stick gave me bed adhesion issues, and i cant easily remove the glass bed.

I think the glass delaminated while it was cooling normally, not when i was prying it off.

[-] CmdrShepard@lemmy.one 1 points 11 months ago

You might look into a smooth build plate. It can take the damage and just be replaced.

[-] CameronDev@programming.dev 1 points 11 months ago

I went with glass originally as it seemed at the time to be durable and therefore less waste. I don't want to generate extra waste. And those pei sheets dont look cheap :/

Thanks for the suggestion though, will keep it in mind

this post was submitted on 06 Nov 2023
17 points (100.0% liked)

3D Printing

4351 readers
1 users here now

For everyhting 3D printing related.

Please be excellent to each other :)

Icon by Freepik, Banner photo by Thiago Medeiros Araujo

founded 4 years ago
MODERATORS
3dnudel@lemmy.ml