3D Printing

5607 readers

4 users here now

For everyhting 3D printing related.

Please be excellent to each other :)

founded 5 years ago

MODERATORS

submitted 3 weeks ago* (last edited 3 weeks ago) by dom@lemmy.ca to c/3dprinting@lemmy.ml

9 comments fedilink hide all child comments

Bambu p1s

Pla. Its been dried in dehydrator for 4 hours at 55

Ironing is off (seemed to be the same with ironing on)

Ive tried turning the temp down to 210

There is a prime tower and purging is set to 1x

Flow rate is 0.96

Aux fan is off

Relatively new nozzle (less than a couple months old and I dont print that often)

I dont know what other info might be relevant

Its not the absolute top surface though, the black icons are raised higher and those look fine.

Really at a loss. Does anyone have any ideas?

you are viewing a single comment's thread
view the rest of the comments

[–] Xander221@lemmy.world 2 points 3 weeks ago

Others have said similar, but make sure the nozzle doesnt plunge into the work and the work doesnt ride up. Bed adhesion, leveling, ect.