3D Printing

5607 readers

4 users here now

For everyhting 3D printing related.

Please be excellent to each other :)

Icon by Freepik, Banner photo by Thiago Medeiros Araujo

founded 5 years ago

MODERATORS

3dnudel@lemmy.ml

I have no idea what's causing parts of my top layers to look so awful. anyone have ideas? (lemmy.ml)

submitted 3 weeks ago* (last edited 3 weeks ago) by dom@lemmy.ca to c/3dprinting@lemmy.ml

9 comments fedilink hide all child comments

Bambu p1s

Pla. Its been dried in dehydrator for 4 hours at 55

Ironing is off (seemed to be the same with ironing on)

Ive tried turning the temp down to 210

There is a prime tower and purging is set to 1x

Flow rate is 0.96

Aux fan is off

Relatively new nozzle (less than a couple months old and I dont print that often)

I dont know what other info might be relevant

Its not the absolute top surface though, the black icons are raised higher and those look fine.

Really at a loss. Does anyone have any ideas?

you are viewing a single comment's thread
view the rest of the comments

[–] richardgunther@twit.social 1 points 3 weeks ago

@dom You sure it's just the top layer? That looks like rubbing that might occur when something's warping off the bed or when the bed isn't leveled. In those cases, it would likely be present in more than just the top layer.