this post was submitted on 25 Feb 2026
106 points (98.2% liked)

Meshtastic

2217 readers
18 users here now

A community to discuss Meshtastic (https://meshtastic.org/docs/introduction)

Other mesh communities:

MeshCore: !Meshcore@feddit.org Reticulum: !Reticulum@mander.xyz

founded 2 years ago
MODERATORS
Sal@mander.xyz
106
Loving the e-ink screen (lemmy.world)
submitted 1 month ago by Dagamant@lemmy.world to c/meshtastic@mander.xyz
6 comments fedilink hide all child comments
 

Seeed Tracker L1 E-Ink. My only issue is that this case orients the screen 90 degrees off of the joystick mapping. I saw something about screen and joystick modifications coming to the inkhub interface but it doesn’t seem to be in the stable beta branch yet.

you are viewing a single comment's thread
view the rest of the comments
[–] fratermus@piefed.social 1 points 1 month ago (1 children)

Loving the e-ink screen

My favorite node is an e-ink e290 (heltec). Unfortunately

  1. it's not supported on MC yet, and my local mesh recently switched to MC
  2. cases are effectively nonexistent -- might have to rent a printer at a makerspace or library and make one
[–] Dagamant@lemmy.world 2 points 1 month ago

I was looking at the Heltec eink nodes. I ended up going with this one because of the chipset and because I could print a nice looking case. The ones out there for the Heltecs were not that great and I’m not good at 3D modeling stuff like that.