Meshtastic

2216 readers

8 users here now

A community to discuss Meshtastic (https://meshtastic.org/docs/introduction)

Other mesh communities:

MeshCore: !Meshcore@feddit.org Reticulum: !Reticulum@mander.xyz

founded 2 years ago

MODERATORS

Sal@mander.xyz

What are some best practices for deploying a mesh? (midwest.social)

submitted 2 months ago by 7toed@midwest.social to c/meshtastic@mander.xyz

8 comments fedilink hide all child comments

Hello again, so far my mesh has been great as a neighborhood range gimmic (no harm, just bummed there aren't more adopters locally), but I'm hoping to go further. Turns out a neighboring town has a more extensive mesh than my own. Aside from convincing a bunch of people in between to set up meshtastic, could I go and set up a yagi and point it towards a known node for example? I am atop a hill and likey have LOS, but even if I get a signal, how should this be repeated if not by another node close to the yagi? Or rethink this entirely? Thank you all in advance

you are viewing a single comment's thread
view the rest of the comments

[–] avidamoeba@lemmy.ca 5 points 2 months ago* (last edited 2 months ago) (1 children)

If you have elevation, you could install two nodes there. One with a yagi towards the other town. The other either with another yagi or an omni for your town's nodes. Then set both nodes to ROUTER_LATE and add them as favourites to each other. Then your local node would go through the first, hop on the second and then shoot towards the other town. It'll lose only one hop over the two routers. More info on that. You could also use two CLIENT or CLIENT_BASE roles but you would lose 2 hops.

E: Also get a 1W RAK if you don't get good signal with your current hardware. I recently bought and tested some and they go markedly further with better signal all else being equal. It's receiving end is also better.

[–] 7toed@midwest.social 2 points 2 months ago (1 children)

It'll lose only one hop over the two routers

Sweet that's just what I was hoping to hear. And those RAK units have sounded real promising, seems like the perfect time to start adopting local meshes

[–] avidamoeba@lemmy.ca 2 points 2 months ago (1 children)

Note that the usual caveats for using ROUTER/REPEATER/ROUTER_LATE roles apply. In your case it might be the right compromise.

[–] 7toed@midwest.social 1 points 2 months ago

Having done a little more scouting around town, I think I discovered a potential black hole router - or simply nobody else is around, hard to judge by signal strength if they're doing good or not. Otherwise I do think I may be in a good spot to try setting up some infrastructure, if only I can get LOS to what seems to be a sparse network.. if there is one lol