FOSSCAD

468 readers

6 users here now

A community dedicated to the discussion of 3D printed guns and related topics.

Lemmy

founded 3 years ago

MODERATORS

sado@lemmy.ml

VZ 61 Skorpion help (lemmy.ml)

submitted 3 weeks ago* (last edited 3 weeks ago) by WW1Historian@fosscad.io to c/fosscad@lemmy.ml

9 comments fedilink hide all child comments

I am having a devil of a time trying to get this damn thing to print. Any advice is appreciated. Most of the issues seem to be around the supports and I just can't find a good position for it to print. Settings are posted below

you are viewing a single comment's thread
view the rest of the comments

[–] StreetSweeper_Arms@forum.guncadindex.com 2 points 3 weeks ago (1 children)

You will need to dial in your support interface settings and cooling then, also if your bed is too hot or cold it can warp. For PLA+ I usually stick at 55-60c.

[–] WW1Historian@fosscad.io 0 points 3 weeks ago (1 children)

I've got it at 60-65 for the bed and 225 for the nozzle (230 for first layer)

[–] StreetSweeper_Arms@forum.guncadindex.com 1 points 2 weeks ago (1 children)

I would bring the bed temp down some and keep the heat the same or down to 220. Cooling settings?

[–] WW1Historian@fosscad.io 1 points 2 weeks ago* (last edited 2 weeks ago) (1 children)

ok. i have the cooling fans running at max after the first layer.

[–] StreetSweeper_Arms@forum.guncadindex.com 2 points 2 weeks ago (1 children)

Probably too much cooling, for PLA+ I never use full fan.

[–] WW1Historian@fosscad.io 2 points 2 weeks ago

I will give this a try thanks!