A place for Plumbers and those interested in Plumbing to ask questions and discuss the trade.
Community guidelines:
If you have a plumbing question please include a picture in your post.
If you have a question such as "does this look correct?" please include the code your area adheres to. If you're not sure please include state/province/country you're in. Codes can vary state to state and what's wrong in one area may be perfectly acceptable in another.
Just as codes vary, prices do too. That's why we won't discuss any pricing because there's so many factors that can't or shouldn't be conveyed to strangers over the internet.
One of my shut off valve need to be replaced. It's a metal valve in a copper pipe.
A plumber proposed a solution, by adding plastic fittings on both ends of the valve.
The plumber said the finished project would be like this (from his previous job at another customer's). (see the fittings in blue circles).
๏ฟผ
I don't know a lot about plumbing code, so I'm seeking advice here. Is it a common practice to add plastic fittings like this?
I'm in Ontario, Canada. Thank you very much ๐
Thank you. I was wondering the same. In this photo, there is space for torch and solder. And a foot of plastic fittings compared to copper isn't going to save a lot. I'm willing to pay $50 or $100 for proper material
Something else I just noticed - that plastic doesn't have any clamps holding it to the wood right there, so every turn of that valve (you know, a shut off valve that gets used once every five years) is going to really stress that plastic.
I'd find a different plumber.