this post was submitted on 05 Feb 2026
297 points (99.0% liked)
Oddly Satisfying
3940 readers
2 users here now
If you like to become a mod in this community, kindly PM the mod.
Things that are strangely gratifying and inexplicably pleasurable.
Rules
- Be respectful and inclusive.
- No harassment, hate speech, or trolling.
- Engage in constructive discussions.
- Share relevant content.
- Follow guidelines and moderators' instructions.
- Use appropriate language and tone.
- Report violations.
- Foster a continuous learning environment.
founded 2 years ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
Ask the installers to bleed it properly or you will have MANY restless nights.
I'm the installer lmao. We got a system with an high power pump cycles every loop multiple times and dumps it in an open container before we connect the heat pump
Is there anything a guy can do about a system like this that gets loud as hell whenever a certain loop is active?
Flushing it helps, try closing the return side to the system and drain water from the manifold while also filling it from your heater, hope you got a drain nearby tho because you gone flush every loop by its on for bit after and presumably you did it right and long enough the air should be gone and it's as quiet as it gets