FOSSCAD

511 readers

1 users here now

A community dedicated to the discussion of 3D printed guns and related topics.

Lemmy

founded 3 years ago

MODERATORS

sado@lemmy.ml

G Spot tuning (forum.guncadindex.com)

submitted 4 months ago by Knobgoblin@forum.guncadindex.com to c/fosscad@lemmy.ml

3 comments fedilink hide all child comments

Slide keeps getting stuck back with a failure to feed. What can I tweak on it? I have the one without the spring on it. Is that one superior?

you are viewing a single comment's thread
view the rest of the comments

[–] Echo419fohammer@fosscad.io 4 points 4 months ago (1 children)

Have you polished your rails and checked if your locking block and slide block for the printed frame not gaming it and is it failing a lot maybe there too much material. Is your trigger OEM or aftermarket?

[–] Knobgoblin@forum.guncadindex.com 5 points 4 months ago

I have not polished anything other than the scs piece. Everything was working fine before I installed it. Trigger is an oem kit off eBay. But I printed the new trigger housing.